Posted by Gordon England (62.252.0.12) on 14:21:18 30/03/05
In Reply to: thickness in plasma spray posted by jitendra u itankar
: sir,
: what is the maximum thickness in plasma spray process on a 20%worn out cast steel cylinder of a servomotor to avoid replacement and also gain its old strength.
Maximum thickness will depend on specific coating material.
Plasma spray coatings will NOT replace the bulk strength lost by wear. It will only restore the dimensions and provide useful surface properties.
Regards Gordon
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.