Posted by Gordon England (62.252.0.12) on 14:36:13 28/02/05
In Reply to:Undercuts posted by Jim
: New to arc spraying.
:
: Is there a technique to reaching undercuts, nonline of sight areas with a arc spray machine?
:
: A attachment that I'm unaware of?
:
: Thanks
Some arc spray guns can be fitted with extensions that permit various spray angles up to 90 degrees for spraying internal diameters etc. Best to ask your equipment supplier/manufacturer.
Regards Gordon
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.