Posted by Dennis Novotny (216.86.70.254) on 17:22:33 25/02/05
I am looking for typical heat treat and/or nitriding procedures for En40B and En351.
Both materials are commonly used in Great Brittian. However, we are a USA based company and information on these materials is hard to find.
Intended use of the alloys is to produce automotive camshafts in low volume production and/or prototype use.
Thanks for any help you can provide or directions on where I can find the help needed. Feel free to contact us directly to keep unnecessary board traffic to a minimum.
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.