Gordon England Surface Engineering Forum

CuZnAl shape memory wire production

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Mehmet Gunhan CIL (85.96.134.82) on 12:13:34 30/12/04

Hi,

I am a mechanical engineering student, and trying to produce a CuZnAl shape memory wire using powder metallurgical route, I guess i should cold press, sinter, wire draw, and again heat treat to "train" the final shapes to "memorise" its shape. But i am not sure, any ideas?

Follow Ups:

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.