[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]
Posted by Srinivasan (220.224.48.4) on 03:23:52 27/11/04
Gentlemen,
I have been dealing with several coating processes for Turbomachinery. For journals, seals areas etc.
We use APS and DE Gun. Here we have a typical requirement where we want to caot the journal of a motor rotor where the Bearing installed is an antifriction bearing. Due to the nature of a application there is a requirement to remove and re-install the bearing every 3 months.
The interference between bearing ID and shaft OD is about 30 microns.
Will Tungsten carbide with de-gun with stand ?
The max thickness I am looking for is 250 Microns on Radius.
Kindly give me you values pinion.
Thanks and best regards,
Srini
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.
