[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]
Posted by paul derrick (217.34.100.25) on 15:22:10 08/11/04
Can you help? I have been advised that when blasting Ti components with AL Ox that we need to fit explosion relief panels to our cabinets to reduce risk of injury if explosion occurs. Is this the case? we have been blasting Ti orthopedic components for about 17 years without incident, now our service contractor says that we need to fit these panels to comply with ATEX regs. Are they just after our business?
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.