[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]
Posted by Bruce Jackson (208.239.159.234) on 18:30:35 11/10/04
I'm looking for way to create a dense pattern of electrically-conductive high points (bumps) on an aluminum surface without stamping or diecasting. What I'm really looking for is a way to "knurl" a flat surface or create a dense, diamond-like pattern. I know about tread plate but my part is too thick and irregular(and the pattern has to dense) to stamp the pattern into it. Also, my volumes will be low so powder metallurgy and other high-volume methods would not be worthwhile. I'm open to ideas and I am grateful for your input.
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.
