Posted by Azim (210.211.203.160) on 04:34:44 14/06/06
Dear Gordon,
This is in furtherance to my post on the 1st of Junue 2006. At the
outset I would like to thankyou for your reply. I would be thankful
if you could help me out on a couple more things in relation to
13%Cr coating on Chilled cast iron calender Rolls.
The finished build up is in the range of 2mm (on
thickness). Since the hardness of the roll is above 55Rc, how
could we go about making grooves ? (tools etc. as the
material is hard)
What abrasive do you recommend for cleaning and blasting ?
Thanks in advance.
Azim
Please go to the new
Surface Engineering Forum as this old message
board is a read only archive. Please copy and paste relevant
information or link to this page if you wish to reactivate this
thread on the new forum. 