Posted by R. Cahill on March 12, 2004 at 02:25:35:
In Reply to: Re: BRA WIRES! Posted by Kellie on March 07, 2004 at 21:17:59:
: : Hi,
: : I am trying to find a suitable product to dip metal bra wires in to coat the ends of them when they have been cut, so they are not sharp and won't poke through fabric. Obviously i do not wish to buy a barrel load! any ideas???
---Interesting. The first thing I thought of for covering sharp metal edges was "JB Weld". In case you aren't familiar with it, it is a type of adhesive, if you will, usually used for holding metal surfaces together, filling cracks, etc. It is something you could dip the wire-ends in that dries solid and won't chip off. You can buy it in small amounts at a hardware or auto parts store.
Ryan
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.
