Gordon England Surface Engineering Forum

BRA WIRES!

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Kellie on March 07, 2004 at 21:17:59:

Hi,

I am trying to find a suitable product to dip metal bra wires in to coat the ends of them when they have been cut, so they are not sharp and won't poke through fabric. Obviously i do not wish to buy a barrel load! any ideas???

Follow Ups:
Re: BRA WIRES! posted by R. Cahill on March 12, 2004 at 02:25:35:

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum. [ Post Followup ] [ Surface Engineering Forum ] [ Thermal Spray Coatings - www.gordonengland.co.uk ]