Gordon England Surface Engineering Forum

Optimum CFM air flow for arc spray

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Derek Richardson on February 19, 2004 at 21:45:18:

Dear Gordon,

Can you tell me what the optimum CFM air flow rate for arc spraying with 1-1/6" Tafa 60T wire should be. I have only managed to find one article that even mentions optimum air flow rates for arc spraying. I currently have a 245 CFM screw compressor, which has died on me and I need to replace it, hopefully with something smaller.

Follow Ups:

Re: Optimum CFM air flow for arc spray Gordon England 13:45:03 02/20/04(0)

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.