Gordon England Surface Engineering Forum

Re: coatings for plastic injection moulds

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Mark Jarratt on February 20, 2003 at 10:44:09:

In Reply to: coatings for plastic injection moulds posted by Paulo Vilaça on February 06, 2003 at 10:49:01:

Hello Paulo,

Teer Coatings Ltd in the U.K. have a number of suitable coatings for the plastic injection industry, most notably two patented coatings, MoST (a MoS2 based coating with metallic addition) and Graphit-iC ( a carbon based coating. Both offer low friction coefficients (0.03-0.05) with exceptional wear resistance (x10-17 m3/Nm). For more information you can visit www.teercoatings.co.uk

Best regards,

Mark

Follow Ups:




Google
 

Post A Message!

Gordon England Surface Engineering ForumPlease go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.




© Copyright Gordon England