Posted by Gordon England on February 12, 2003 at 19:24:14:
In Reply to: Re: Thermal Spray Coatings On Cast Iron posted by Gordon England on February 12, 2003 at 18:31:37:
: : Does anyone have any experience of thermal spray coatings applied to cast iron, in particular SG iron. Info on expected bond strength compared to coatings on steel components would be appreciated
: : If you wish to email, remove NOSPAM from the email address
: : Thanks
: : Geoff
: Hi Geoff
: A minor reduction in adhesion strength may be expected, but nothing to worry about. Some cast irons though, can be porous and hold oil, cutting fluids etc. and care is needed to remove this before grit blasting and spraying or adhesion will be adversly effected.
: Regards Gordon
This site is protected by WPOISON in an attempt to stop email harvesting, although I'm not sure if it is 100% effective. Geoff is wise and has shown us another simple way to hide email addresses from email harvesting spiders/robots by inserting NOSPAM into the address. Slightly inconvenient, but better than being bombarded with junk mail.
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.
