Posted by Mick on June 07, 2003 at 09:47:37:
In Reply to: Re: Ceramic Coating for Electrical Insulation posted by Gordon England on May 22, 2003 at 17:28:43:
Plasma Sprayed Metco 105SFP gives the best dielectric strengths of all the ceramics. It can give up to 500 volts per 0.001" if properly sealed (Metcoseal AP or AG.)For this application of 100V you would probably think that only a couple of "thou"would be required but this is below the minimum thickness that we like to spray them, so go for about 0.005"-0.010"
Good Luck.
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.
