Gordon England Surface Engineering Forum

Flow settings

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Joe Dufresne on May 24, 2003 at 20:35:19:

I have been using the flow meter settings of 44oxy 44acety on aluminum, bronze, copper. Could you give me the correct settings for the three wires using a 3GF Metco flowmeter. Thank you

Joe Dufresne

Follow Ups:

Re: Flow settings Gordon England 12:10:03 06/09/03(1)
Re: Flow settings Joe Dufresne 00:26:04 06/04/03(4)
Re: Flow settings Gordon England 10:36:37 06/02/03(5)
- Re: Flow settings Joe Dufresne 01:13:15 06/10/03(0)
- Re: Flow settings Gordon England 11:32:09 06/09/03(3)

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.