Gordon England Surface Engineering Forum

Re: plasma coating chipping after machining

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Gordon England on April 25, 2003 at 12:12:51:

In Reply to: plasma coating chipping after machining posted by Kevin Liu on April 25, 2003 at 08:24:03:

: We have a plasma coating process that spray 0.025"
: thickness METCO 450NS powder onto a concave surface
: (about 1" inch ID), the coating was chipped after
: machining. Appreciate, if someone has good suggestions
: to figure out plasma coating chipping problem ? TKS

Hi Kevin

Is coating chipping from edge? Please give more detail on problem.

Regards Gordon

Thermal Spray Coatings

Follow Ups:

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.