Gordon England Surface Engineering Forum

Re: coatings for plastic injection moulds

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Mark Jarratt on April 23, 2003 at 17:30:40:

In Reply to: Re: coatings for plastic injection moulds posted by Gordon England on February 13, 2003 at 10:52:23:

I work for a PVD coatings company. Coating allocation is dependent on the type of plastic to be moulded. TiAlN, and CrN are the most common but a hard carbon coating Graphit-iC TM has also shown excellent results for some plastics where release problems have been evident.

My web site

Follow Ups:

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.